Purge housings for Valco valves eliminate any possible diffusion from the atmosphere into the valve, or safely vent fugitive emissions from the valve. They are typically used in trace level analyses to isolate the valve from ambient air, but can also be used as a safety measure to isolate a valve against leaks into the atmosphere, such as when pyrophoric, toxic, or carcinogenic materials are present in the sample stream.
Two screws secure each half of the purge housing to the valve, so that the rear chamber of the housing (the preload assembly/spring side of the valve) can be removed for rotor inspection or replacement without affecting the actuator side of the housing. (See exploded view)
Because there are so many variables, purge housings are not available for purchase on the website. Please contact the factory for assistance.
Field installation of purge housings is not recommended. Ideally, the purge housing should be ordered at the same time as the valve so that it can be factory installed. An existing valve can be returned to the factory to have a purge housing retrofitted. Purge housings require a standoff assembly, which can be 2, 3, 4, or 6” long. Multiposition valves also require an actuator – no manual version is available.
Exploded view of purge housing.
|本公司將於9/18-9/20參展2019 SEMICON TAIWAN，攤位號碼：L0306，歡迎蒞臨指導!|
|AAT 核酸染劑 Cyber Green/ Cyber Orange - 想怎麼染就怎麼染 (內染/外染/染樣品) 特優惠價專刊 ! 至 7 月底止|
|有立公司 5/25~5/29 舉行員工旅遊 5/30正式上班|